[Contents] [Prev] [Next] [Index] [Report an Error] [No Frames]

SDX 6.4.x Network Guide > Using JUNOSe Routers in the SDX Network > Stopping the SDX Client on a JUNOSe Router

Stopping the SDX Client on a JUNOSe Router

JUNOSe routers use an SDX client to interact with the SAE. See JUNOSe Broadband Access Configuration Guide for complete information about configuring the SDX client on the JUNOSe router.

To stop the SDX client:

  1. Access the router CLI.

See Accessing the Router CLI.

  1. Access Global configuration mode. 
    2. host1#configure terminal
  2. Switch to the virtual router for which you want to stop an SDX client.
    3. host1(config)#virtual-router <vrName>
  3. Disable the SDX client.
    4. host1:<vrName>(config)#no sscc enable
[Contents] [Prev] [Next] [Index] [Report an Error] [No Frames]