SDX 6.4.x Integration Guide > Integrating eTrust Directory > Integrating the eTrust Directory with the SDX Software

Integrating the eTrust Directory with the SDX Software

The tasks to integrate the eTrust Directory software with the SDX software are:

1. Installing eTrust Directory to Integrate with the SDX Software
2. Configuring the SDX eTrust Directory Server Agent

Installing eTrust Directory to Integrate with the SDX Software

To install eTrust Directory:

• Use the eTrust express installation to install eTrust Directory on your Solaris system. See the documentation for eTrust Directory.

The installation process creates a user ID named dsa that is the administrator user ID for eTrust Directory. Assign a password to this user ID.

Configuring the SDX eTrust Directory Server Agent

You integrate eTrust Directory with the SDX software by running commands provided by the eTrust Directory add-on package.

Before you run these commands, ensure that the add-on package is installed on the system on which the eTrust Directory is installed. For information about installing the package, see SDX Getting Started Guide, Chapter 5, Installing the SDX-300 Software.

To integrate eTrust Directory:

1. Navigate to the following directory:

/opt/UMC/conf/etrust

2. Log in using the dsa user ID and the associated password, and run the setup.sh script by entering the following command:

./setup.sh

When the script starts, you see the following information on the screen:

3. Login as root and run the load script by entering the following command:

./load

4. Select sample data to load when prompted.

When the sample data is loading, you may see messages that indicate that some entries are already present. The load script generates these messages for different LDIF files that contain the same data. You can ignore these messages.

For information about the tasks that the script completes, see About the eTrust Directory Add-On Package.