NMC-RX 7.3.x User Guide, Vol. 1 > Configuring T3/E3 and T1/E1 Modules > Configuration Tasks

Configuration Tasks

Typically, you configure channelized or unchannelized modules in the following order. Some steps may not apply for a particular module.

1. Set the parameters that provide basic identification and status information about the module.
2. Set the line interface parameters.
3. Set the DS1 interface parameters.
4. Configure the DS0 bundle parameters. (See Chapter 14, Configuring DS0 Bundles.)
5. Configure the:

• ATM interfaces (see Chapter 18, Configuring ATM)
• Bridged IP/1483 interfaces (see Chapter 20, Configuring Bridged IP)
• Cisco HDLC interfaces (see Chapter 23, Configuring Cisco HDLC)
• Frame Relay interfaces (see Chapter 24, Configuring Frame Relay)
• IP interfaces (see NMC-RX User Guide, Vol. 2, Chapter 6, Configuring IP)
• MLPPP bundles (see Chapter 25, Configuring MLPPP Bundles)
• PPP interfaces (see Chapter 27, Configuring PPP)
• PPPoE interfaces (see Chapter 28, Configuring PPP over Ethernet)