Known Limitations
This section lists the known limitations in Release 7.3.0.
- The Provisioning Service (PVS) supports up to twenty CORBA clients connected at the same time. There is a limitation such that the CORBA clients cannot initialize their connections to PVS simultaneously. Each CORBA client needs to be started and initiate its connection to PVS one at a time. Once the client's initial connection to PVS is made, PVS can support requests from other clients (up to 20) at the same time.
- When you click Install on the Pre-Install Summary dialog box during installation, there is a short amount of time when the database updates. If you click Cancel during this time, the database remains locked for the installation of additional Config Sync Services.
Recommendation: Do not click Cancel after the installation begins. Instead, allow the installation to complete, and then use the NMC-RX Uninstaller or Config Sync Services uninstaller to remove the desired components.
- When you use Bulk Services to create a large number of objects, limit the number of objects to a maximum of 9000. Otherwise, you run the risk of running out of memory. To create additional objects, you can exit the NMC-RX application and then restart.
- Currently, the NMC-RX application allows you to start multiple Polling Services at the same time. Only one Polling Service is actually used by the application. There will be no disruption of service if you start additional services; however, it is a waste of resources to do so, and currently no error message is displayed to indicate any displacement of the service being used. All instances of polling should be closed, and only one restarted.
- When the Config Sync Services and the Polling Service are started before the database has completely initialized, an error occurs.
Recommendation: Wait until the database is initialized before launching other NMC-RX components. If an error has occurred, close all NMC-RX components (including the database) and start over.
- An error may occur if, during a device update, you attempt to make changes to a scheduled task and save them.
Workaround: Wait until the device has been updated, and then edit the scheduled tasks.