NMC-RX 7.2.x User Guide, Vol. 1 > Configuring ATM > Creating an ATM Circuit

Creating an ATM Circuit

In the NMC-RX application, you need to navigate to the ATM subinterface level to create an ATM circuit for the module.

To create an ATM circuit:

1. Navigate to the ATM subinterface in the list area.
2. In the list area, click a subinterface, right-click, select Create, and click ATM Circuit.

The Create ATM Circuit dialog box appears.

3. Set the ATM circuit parameters (Table 63).

 Table 63:  ATM Circuit Parameters  

 Parameter
 Description

 Logical Name

 Identifies the particular instance; generated automatically


 Admin Status


  
 Up—Interface is enabled by the administrator
  
 Down—Interface is disabled by the administrator



 AAL5 Encapsulation


  
 rfc1483VcMux—aal5muxip 
  
 rfc1483Llc—aal5snap



 Service Category

 Service category for traffic management:

  
 ubr—Unspecified bit rate traffic management; select if no VCs require traffic shaping
  
 ubrPcr—Unspecified bit rate peak cell rate; select for PCR only
  
 nrtVbr—Non-real-time variable bit rate; can select for PCR, SCR, or MBS



 VPI

 Virtual path identifier; dependent on values set on ATM interface; range 0- 55
 NOTE: The VPI and VCI values cannot both be set to 0.


 VCI

 Virtual circuit identifier; dependent on values set on ATM interface; range 0-65535
 NOTE: The VCI and VPI values cannot both be set to 0.


 VCD

 Virtual circuit descriptor; dependent on values set on ATM interface; range 1-4294967295


 PCR

 Peak cell rate; value must be greater than or equal to SCR

  
 OC3, OC3-ATM, OC12-ATM: range 1-99999
  
 E3: range 64-30528
  
 T3: range 64-44209



 SCR

 Sustained cell rate

  
 OC3, OC3-ATM, OC12-ATM: range 1-99999
  
 E3: range 64-30528
  
 T3: range 64-44209



 MBS

 Maximum burst size

  
 OC3, OC3-ATM, OC12-ATM: range 1-99999
  
 E3: range 64-30528
  
 T3: range 64-44209



 NBMA Parameters

 Inverse ARP

 Enables InARP on the circuit


 ARP Refresh Rate (Min.)

 Specifies refresh rate for ARP in minutes; range 1-60


 OAM Settings

 Status

 Enables OAM F5 loopback cell generation on the circuit; enables VC integrity features that have an effect on the operational state of the ATM PVC


 Loopback Frequency

 Time interval in seconds between transmissions of OAM F5 loopback cells; range 0-600. If this option is not specified, OAM F5 loopback cells are generated once every 10 seconds.



 

4. Click OK.