NMC-RX 7.2.x User Guide, Vol. 1 > Configuring ATM > Creating an ATM Subinterface

Creating an ATM Subinterface

You can create an ATM subinterface from the interface or from a VP tunnel.

NOTE: Although these steps describe creating an ATM subinterface on an ATM interface, they can be used to create subinterfaces on a VP tunnel.

To create an ATM subinterface:

1. Navigate to the ATM interface in the list area.
2. Select a subinterface, right-click, select Create, and click ATM Sub Interface.

The Create ATM Sub Interface dialog box appears.

3. Set the ATM subinterface parameters (Table 62).
   

   NOTE: For information about dynamic interfaces, see NMC-RX User Guide, Vol. 2, Chapter 7, Configuring Profiles.

   
   

 Table 62:  ATM Subinterface Parameters 

 Parameter
 Description

 Name

 Identifies the interface; generated automatically


 Alias

 Description of the interface; 0-15 characters; default: blank


 IfIndex

 Identifies the interface on the particular line interface; generated automatically


 Operational

 Current operational status of the interface


 Administrative

 Desired status of the interface: Up/Down; default: Up


 Dynamic Interfaces

 Encapsulation

 Specifies the type of dynamic encapsulation that will accept and detect the ATM 1483 subinterface


 Profile Name

 Click 
to choose a profile from the Associate Profile dialog box. See Related Dialog Boxes.


 Auto Configure

 Enables autoconfiguration, which causes the ATM subinterface to support a dynamic interface


 Enable

 Select to append subscriber information


 Details

 When Enable is checked, this field becomes active. Click 
to display the Subscriber Details dialog box. See Related Dialog Boxes. 
 Then configure a local subscriber on the E-series device to support authentication and configuration from RADIUS for a dynamic IPoA interface.






 QoS

 Profile Name


  
 Name of the attached QoS profile (a collection of QoS commands that specify queue profiles and scheduler profiles in combination with interface types)
  
 Enabled only on OC3 ATM-4 port, OC12 ATM-1 port, T3 ATM-4 port line modules
  
 Set value by clicking 
and selecting a QoS profile from the Associate QoS Profile dialog box.




 

4. Click OK.

Related Dialog Boxes

Profile Name

The Associate Profile dialog box appears when you click in the column next to Profile Name in the Create ATM Sub Interface dialog box. Use it to select a profile.

1. Click a profile.
2. (Optional) Click View to display the profile's full configuration.
3. Click OK.

The information is entered in the Create ATM Sub Interface dialog box.

Details

The Subscriber Details dialog box appears when you click in the Details column in the Create ATM Sub Interface dialog box. Use it to configure a local subscriber (when one cannot be obtained externally) on the E-series device to support authentication and configuration.

1. Complete each field.

• Name Prefix Enabled—Specifies how the supplied username is used for authentication purposes. Select to add the username to the beginning of the interface physical location identifier.
• Password Prefix Enabled—Specifies how the supplied password is used for authentication purposes. Select to add the password to the beginning of the interface physical location identifier. Password usage is optional.

2. Click OK when done.

The information is entered in the Create ATM Subinterface dialog box.