Configuring the System > Using the User Inactivity Timer

Using the User Inactivity Timer

You can use the user inactivity timer to specify the period of time that the NMC-RX application waits before it closes due to user inactivity. If you do not perform any tasks (view, configure, update, etc.) in the time specified, a message dialog box appears indicating that your session has ended.

When you click OK, all open dialog boxes and workshops close and the NMC-RX application exits. You must restart the application and log in again to continue using it.

The timer is reset each time you click the mouse or press a keyboard key within the NMC-RX application. When the application is busy, the timer is disabled but restarts when the task is completed.

Configuring the User Inactivity Timer

NOTE: Only users with a security privilege can configure the user inactivity timer. For more information, see Chapter 8, Configuring Security Settings.

To enable or disable the user inactivity timer:

1. From the Configuration menu, select NMC-RX Application Settings, then click User Inactivity Timer.

The User Inactivity Timer tab appears in the work area.

2. Set parameters (Table 14).

• To enable the timer, select the Enable Inactivity Timer check box, and enter a value in the field.
• To disable the timer, clear the Enable Inactivity Timer check box.

Table 14: User Inactivity Timer Parameters

 Parameter
 Description

 Enable Inactivity Timer

 Enables or disables the timer


 Inactivity timeout (min)

 Number of minutes to wait before exiting the application during a period of inactivity; range 5-1000 minutes; default is set during installation



 

3. Click Save.

All current sessions are updated when the timer starts again.