Configuring Channelized OC Modules > Configuring Modules

Configuring Modules

You can configure only the admin status of a module.

To configure a module:

1. In the Instance Explorer list, select the module that you want to configure.
2. Right-click, and select either Map to T1 or Map to E1.
3. Right-click again, and click Configure.

The Module Config tab appears in the work area. Note that the operation mode is set to the option you chose in Step 2.

4. Set the admin status (Table 34).

 Table 34:  Module Configuration Parameters  

 Field 
 Description

 Module Type

 Module type (cannot edit)


 Admin Status


  
 Enabled—Module is running
  
 Disabled—Module is not in operation



 Operation Mode

 Displays if module is mapped to a T1 or E1 line module


 Serial Number

 Ten-digit identification number (S/N) on the faceplate of the module. This value is automatically retrieved from the device, and you cannot edit it.


 IOA Serial Number

 Ten-digit identification number (S/N) on the faceplate of the input/output adapter. This value is automatically retrieved from the device, and you cannot edit it.



 

5. Click Save.