Configuring Bridge Interfaces > Creating Bridge Interfaces

Creating Bridge Interfaces

On an E-series device, you can create bridge interfaces over an ATM 1483 subinterface, an Fast Ethernet interface, or a Gigabit Ethernet interface. The procedure for creating bridge interfaces is basically the same regardless of what interface you create them on.

NOTE: Before creating a bridge interface using the NMC-RX application, you must create a bridge group using the CLI.

To create a bridge interface on an ATM 1483 subinterface:

1. In the Device-wide Explorer, select Bridged IP (RFC 1483), right-click, and select List All.
2. In the list area, select the Bridged IP (RFC 1483) subinterface you want, right-click, select Create, and click Bridge Interface.

The Create Bridge Interface dialog box appears.

3. Set the bridge interface parameters (Table 63).

 Table 63:   Bridge Interface Parameters  

 Field 
 Description

 Name

 Identifies the interface; generated automatically; cannot edit


 IfIndex

 Identifies the interface on the particular line interface; generated automatically; cannot edit


 Operational

 Current operational status of the interface; cannot edit


 Administrative

 Desired status of the interface: Up/Down; default: Up


 Bridge Group Name

 Click 
 to select a bridge group from the Associate Bridge Group dialog box. See Related Dialog Box.


 Subscriber-Trunk

 Enables subscriber-trunk mode; default: unselected


 Max Learned MAC Addresses

 Maximum number of learned MAC addresses; 0 indicates that there is no limit; range 0-64000; default 0



 

4. Click OK.

The bridge interface is created.

NOTE: Bridge interfaces appear in the Instance Explorer only when created on a Fast Ethernet or a Gigabit Ethernet interface. To list all bridge interfaces on a system, double-click Bridge Interface in the Device-wide Explorer.

Related Dialog Box

Associate Bridge Group

The Associate Bridge Group dialog box appears when you click next to the Bridge Group Name field in the Create Bridge Interface dialog box. Use it to select a bridge group.

• Select a bridge group name, and click OK.

The bridge group name is entered in the Bridge Group Name field.