Removing Config Sync Services from the NMC-RX Database

When the status of a selected Config Sync Service is either Not Responding or Not Run Yet, the Remove button in the Config Sync Services tab is enabled. When you remove a Config Sync Service, you clear it from the NMC-RX database.

NOTE: Perform this action only if you uninstalled the Config Sync Service and the uninstaller had a problem clearing the service from the database. For more information about uninstalling a Config Sync Service, see Uninstalling Config Sync Services.

To remove a Config Sync Service:

1. In the Configuration menu, choose NMC-RX Application Settings.

The Config Sync Services tab appears.

2. Select the Config Sync Service that you want to remove; then click Remove.

A warning dialog box appears indicating that if you remove the service, you cannot use it until it is reinstalled.

3. Click Yes to remove the Config Sync Service.

The IP address of the workstation on which the Config Sync Service was installed is removed from the Config Sync Services table, but the service ID remains. You cannot use this service ID until you reinstall the Config Sync Service.