Starting the JUNOScope Installation from the CD-ROM

To run and start the JUNOScope installation from the product CD-ROM, follow these steps:

1. Insert the JUNOScope software CD-ROM into the CD-ROM drive.
2. Mount the CD-ROM. For example, specify /mnt.
3. Start the JUNOScope installation with the following command:

hostname% cdrom-mount-directory/jtk-installer install-directory

   
NOTE: If you do not specify an installation directory for the JUNOScope software, the software will be installed into the current directory.


 

Replace cdrom-mount-directory with the directory on which the CD-ROM is mounted—either /mnt, /cdrom, or /cdrom/JUNOScope, depending on your host setup.

Replace install-directory with the directory in which to install the JUNOScope software. If you do not specify an installation directory, the software is installed in the current directory.

For information on installing JUNOScope, see Installing the JUNOScope Software.