AIS Setup Sequence

This chapter describes the sequence required to set up Advanced Insight Solutions (AIS) successfully. See Figure 7.

Figure 7: Sequence for Setting Up AIS

This chapter includes the following sections:

• Installing the JUNOScope Software (Optional)
• Setting Up the JUNOScope Software (Optional)
• Installing AIM
  

  NOTE: It does not matter whether AI-Scripts or AIM is installed first. However, for both, it is necessary, to know the archive location (archive-site destination) used for devices to send incident and intelligence JMBs and for AIM to retrieve this data. You can add the archive location to the device JUNOS configuration for both AI-Scripts and AIM after the initial installation, but the components are not really usable until the archive location is configured.

  
  
• Setting Up AIM
• Installing AI-Scripts